Table of Contents
Advertisement
MECHANICAL LINK (M155, M105 OPTIONAL)
WARNING
Stop windrower engine, and remove key
before making adjustments to machine. A
child or even a pet could engage the drive.
O
1. Stop engine, and remove key from ignition.
2. Loosen nut (M), and rotate barrel (N) to adjust
length so that the link line s-up with header
bracket.
3. Install pin (O), and secure with cotter pin.
4. Adjust link to required length for proper
header angle by rotating barrel (N). Tighten
nut (M) ag ainst barrel. A slight tap with a
hammer is sufficient.
CAUTION
Check to be sure all bystanders have cleared
the area.
REEL DOWN
HEADER UP
HEADER
TILT DOWN
HEADER DOWN
Form 169542
UNLOADING AND ASSEMBLY
M
N
REEL UP
HEADER TILT UP
k. If engine is not running, start engine, and press
HEADER UP switch to raise header to maximum
height.
If one end of the header does not raise
fully, the lift cylinders require re-
phasing.
proceed as follows:
1. Press and hold the HEADER UP switch until
both cylinders stop moving.
2. Continue to hold the switch for 3–4 seconds.
3. Cylinders are phased.
DANGER
To avoid bodily injury from fall of raised
header, always engage header lift cylinder
stops when working on or around raised
header, and before going under header for any
reason.
l.
Cylinder stops are lo cated on both hea der lift
cylinders on the windrower. Engage lift cylinder
stops on both lift cylinders as follows:
1. Stop engine, and remove key from ignition.
2. Pull lever (P), and rotate toward header to
release and lower cylinder stop (Q) onto
cylinder.
3. Repeat for opposite lift cylinder.
73
NOTE
If re-phasing is needed,
P
Q
(continued next page)
Revision F
Advertisement
Table of Contents
