Operator's Presence System Checks - MacDon M 2009 Series Assembly Instructions Manual

VI. OPERATOR'S PRESENCE SYSTEM
CHECKS
M155, M205 SHOWN - M105 SIMILAR
a. With the windrower engine running, place the
GSL (A) in NEUTRAL, and turn the steering
wheel until it locks.
CAUTION
Check to be sure all bystanders have cleared
the area.
b. With everyone clear of the machi ne, engage
HEADER DRIVE switch (B).
1. After header drives are running, stand up out
of the seat. In app roximately 5 second s the
header should shut off.
If not, the Operator Presence System requires
adjustment.
Manual.
To re-start the header, move the
HEADER DRIVE switch (B) to the OFF
position and back to the ON position
again.
c. M155, M205 ONLY: With the engi ne running,
position the GSL (A) in NEUT
N-DETENT:
1. Swivel the Operator's station, but do not lock
into position.
2. Move GSL o ut of N-DET ENT. The e ngine
should shutdown, and the lower display will
flash "LOCK SEAT BAS E ---> CENTER
STEERING WHEEL ---> NOT IN NEUTRAL".
3. Swivel and lock the Operator's station, and
the display should return to normal.
Form 169242
PRE-DELIVERY CHECKS
A
B
Refer to Tec hnical Service
NOTE
RAL, and in
4. If the engine does not shut down, the seat
position switches require adjustment. Refer to
Technical Service Manual.
d. With the windrower moving at less than 5 mph
(8 km/h):
1. Stand up out of the seat.
2. The CDM will flash "NO OPERATOR" on the
upper line, and "ENGINE SHUTDOWN
5...4...3...2...1...0"
accompanied by a steady tone. At "0", the
engine shuts down.
3. If the engine doe s not shut do wn, the
Operator
adjustment.
Manual.
e. With the windrower moving at more than 5 mph
(8 km/h):
1. Stand up out of the seat.
2. The CDM beeps once, and displays "NO
OPERATOR" on the lower line.
3. If not, the Operator Presence System requires
adjustment.
Manual.
110
on the lowe r
Presence System
Refer to Tec hnical Service
Refer to Tec hnical Service
Revision F
line
requires