Table of Contents
Advertisement
B. M155
a. The hydraulic hoses under the cab may require
proper placement under the existing clip. If
necessary, proceed as follows:
1. Locate hose clip under the cab, and remove
clip.
VIEW LOOKING FORWARD
2. Position hose 111323 (orange tie) and hose
111324 with tee (white tie), as sho wn under
the center of the clip, a nd loosely install two
bolts and nuts. Part numbers are located on
hoses. (If M2 00, place an other hose 1132A
with tee under clip)
3. Position remaining hoses under clip as shown,
and tighten bolts.
Form 169542
UNLOADING AND ASSEMBLY
111557 YELLOW
111323 BLUE
111323 ORANGE
111324 WHITE 'T'
111324 (M200 ONLY)
(NOT SHOWN)
111327 GREEN 'T'
111328 WHITE
33
b. Connect hoses as follows, using colored plastic
cable ties as a guide.
111327 GREEN
1. Locate two hoses 111327 (green tie s) in
frame opening, and existing tee fitting (green
tie).
2. Remove caps on green lines and tee, and
make connections. Tighten fittings.
NOTE
Remove caps on tee last to minimize oil
loss.
3. Position hoses into frame.
4. Locate two h oses (white ties) in side frame,
and hose 111324 with tee (white tie).
5. Remove caps, make connections, and tighten
fittings.
6. Push hoses into frame.
111324 WHITE 'T'
(continued next page)
Revision F
Advertisement
Table of Contents
