Gpio Control Tab - evertz 7812UDXD Series Manual

The General Level controls the strength of the applied General Noise Reduction filter. Select the level of
noise reduction to be applied by selecting the appropriate value from the drop down menu as shown
below.
Off
Low
Medium Low
Medium
Medium High
High

Note: Setting the value higher than needed to remove the noise present will over
soften areas of low amplitude, fine details.

Note: Setting the value too low may cause the circuitry to leave random noise that it
could remove. However, removal of low-level details will be minimized

6.25. GPIO CONTROL TAB

This GPIO Control tab allows the user to define the direction and function of each of the module's GPIOs.
For the sake of brevity, only the controls for GPIO1 will be discussed. GPIO2 to 8 operates in the same
fashion.
GPIO1 may be configured to be a GPI or a GPO. When set to operate as a GPI, the user may use the
GPI to recall a card preset or trigger the playing/looping of a particular set of side panel logos. When set
to be a GPO, the user may use the GPO to "tally" a particular logo that is being played/looped or a
particular card preset that has been selected.
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
General noise reduction will not be enabled.
A Low level of general noise reduction will be applied.
A Medium Low level of general noise reduction will be applied.
A Medium level of general noise reduction will be applied.
A Medium High level of general noise reduction will be applied.
A High level of general noise reduction will be applied.
Revision 1.1.1
7800/7700 MultiFrame Manual
Page - 81