2.Dolby Metadata Vanc Input Sdid; Output Video 1, Vanc Output 1; 1.Vanc Output Source Select; 2.Dolby Metadata Vanc Output Line - evertz 7812UDXD Series Manual

6.28.1.2. Dolby Metadata VANC Input SDID
This control sets the input SDID for the Dolby Metadata ancillary data packets. To adjust the control, drag
the slider right to increase the value and left to decrease the value. The SDID Control value ranges from
0x1 to 0xFF. The default value is 0x1.

6.28.2. Output Video 1, VANC Output 1

6.28.2.1. VANC Output Source Select
This control allows the user to enable or disable the Dolby Metadata Encoder. When set to Disable, Dolby
Metadata authoring and insertion will not be enabled. When set to Enable, Dolby Metadata authoring and
insertion will be enabled. A full list of selectable options is shown below:
Disable
Dolby Decoder A
or B
External Input 1
VANC Input 1 or
2
Metadata Adjust
A or B
Metadata Author
A or B
6.28.2.2. Dolby Metadata VANC Output Line
This control enables the user to adjust the line on which Dolby metadata is encoded. To adjust the control,
drag the slider right to increase the value and left to decrease the value. The Output Line value ranges
from 7 to 41 in increments of 1 line. The default setting is 18.
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Dolby Metadata authoring and insertion will not be enabled.
Dolby Metadata authoring and insertion will be enabled sourced by
either decoder A or decoder B.
Dolby metadata VANC output will be sourced by the external Metadata
input on the rear-plate.
Dolby Metadata VANC output will be sourced by the incoming VANC
source 1 or 2
Dolby metadata VANC output will be sourced by the Metadata Adjust
Tab through the A or B metadata adjust controls.
Dolby metadata VANC output will be sourced by the Metadata Author
tab in either the Metadata Author A or B controls.
Revision 1.1.1
7800/7700 MultiFrame Manual
Page - 89