Table of Contents
Advertisement
6.50.7.4.7.
Start/Continue
The Start/Continue control will commence or resume the duration in which loudness values are being
used to calculate the Integrated Loudness measurement.
6.50.7.4.8.
Stop/Pause
The Stop/Pause control will terminate or pause the duration in which loudness values are being used to
calculate the Integrated Loudness measurement. Each time this button is activated, a new Integrated
Loudness value will be produced.
6.51. INTELLIGAIN TRAPS TAB
The IntelliGain system can provide real time analysis and confidence monitoring with SNMP trap alarm
notification. These alarms can be enabled and disabled on an individual audio program basis using the
IntelliGain Fault Traps configuration tab.
To enable or disable an SNMP alarm notification, either check or un-check the defined control.
The system also provides real time trap status information. If a trap is sent by the IntelliGain system,
the trap status box will change state indicating the real time value for that trap. For example, if the trap
status box is the colour green, then the trap has not been sent. However, if the status box is the colour
red, then the fault is in a current state of alarm. Once corrected, the status box will turn back to the colour
green.
IntelliGain Traps tab identifies the VistaLINK
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
configuration view for the IntelliGain Fault Traps.
®
Revision 1.1.1
7800/7700 MultiFrame Manual
Page - 177
Advertisement
Table of Contents
