Table of Contents
Advertisement
7800/7700 MultiFrame Manual
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
6.17.1.3. Auto Recall Presets for Specific Video Input Standards
The Auto Recall Presets functionality is used to automatically recall card configurations for specific video
input standards. The user must define these format dependant card configurations using VistaLINK
PRO. Once this is complete, they will automatically be recalled once that particular video standard is
detected on the module itself. To utilize this functionality, the following steps must be performed:
1) Enable the Auto Recall Presets functionality in the Utilities control tab.
2) Set the input video standard for which you wish to define the card preset. This is done in Video
control tab.
3) Proceed to configure as desired ensuring that you press APPLY each time a parameter is
changed.
4) Proceed to the Utilities control tab and select the Auto Recall option in the Store User Preset
control drop down menu.
5) Repeat steps 2-4 for each input video standard
NOTE:
The Auto Recall Presets functionality should be used with care.
All card parameters are recalled when a new video input standard is detected. When Auto
Recall Presets is enabled, changing any particular card parameter (Y Gain just as an
example) will take effect only for that particular video input standard. It will not be stored for
all operating modes. When a new video input standard is detected, a new value for that
particular card parameter may be recalled. Parameters must be specifically set for each
video input standard if you desire the same parameter value to be recalled all the time.
Note that this also includes items like GPIO settings and which User Presets they recall. If
the GPIO settings are not specifically set for each and every possible video input standard,
the GPIO functions could change when the new video input standard is detected.
Auto Recall Presets functionality is disabled.
Disable
Each time a particular combination of video input/output standards is selected, the
module will automatically recall the defined preset for the combination of
Enable
input/output video standards.
6.17.2. User Sub-Preset Single Load
This control is used to initiate a store to a saved card configuration into one of the user presets. To store a
card configuration to a specific preset, select the preset to which you wish to store the card settings and
press upload the associated Sub-Preset XML file. There are 10 presets to which you can store a Sub-
Preset.
6.17.3. User Sub-Preset Multiple Load
This control is used to initiate a store of multiple XML configuration files to the card configuration into the
user presets. To store the card configurations to the presets, a script file must be created which contains
the information on the XML files to be used and the User Preset location they will be stored to along with
the IP address for purpose to load with FTP. There are 10 user presets to which you can store a Sub-
Preset.
Page - 64
Revision 1.1.1
®
Advertisement
Table of Contents
