Table of Contents
Advertisement
Last Pixel Num in SD Prod Ap
First Line Num in SD Prod Ap
Last Line Num in SD Prod Ap
First Pixel Num in SD Clean Ap
Last Pixel Num in SD Clean AP
First Line Num in SD Clean Ap
Last Line Num in SD Clean Ap
Image Enhancement Enable
Detail Gain
Enhancement Limit
Horizontal Band
Vertical Intensity
Luma Floor
Detail Noise Floor
AFD Input Enable
Loss of AFD Mode
AFD Stamp Source
Output SD Aspect Ratio
AFD Output Enable
AFD Output Line
AFD Select
AFD Stamp
Aspect Ratio Conversion
Input H Start
Input H Stop
Input V Start
Input V Stop
Output H Start
Output H Stop
Output V Start
Output V Stop
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Defines the last active horizontal pixel for the SD Production
Aperture.
Defines the first active line for the SD Production Aperture.
Defines the last active line for the SD Production Aperture.
Defines the first active horizontal pixel for the SD Clean Aperture.
Defines the last active horizontal pixel for the SD Clean Aperture.
Defines the first active line for the SD Clean Aperture.
Defines the last active line for the SD Clean Aperture.
Enables the Image Enhancement control settings.
Selects the level of the detail gain.
Sets the maximum enhancement allowed.
Sets the horizontal frequency band.
Sets the intensity of vertical enhancement.
Sets the gamma correction factor.
Sets the minimum level of detail required before the enhancer is
enabled.
Enables the input side AFD processing.
Configures the action that the converter will take when incoming
AFD signals are lost.
Sets the source for output AFD stamping.
Defines whether SD outputs should be stamped with an AFD
value that indicates a 16:9 or 4:3 output image raster.
Enables the insertion of AFD packets in the outgoing video signal.
Sets the AFD Output Line level.
Selects the incoming AFD code.
Specifies the outgoing AFD code.
Selects the ARC processing that the card will perform.
Sets the left side crop positions.
Sets the right side crop position.
Sets the top crop position.
Sets the bottom crop position.
Sets the left side of the output.
Sets the right side of the output.
Sets the top of the output image.
Sets the bottom of the output image.
Revision 1.1.1
7800/7700 MultiFrame Manual
Page - 195
Advertisement
Table of Contents
