Jumpers; Selecting Whether Local Faults Will Be Monitored By The Global Frame Status; Figure 7-1: Location Of Jumpers - Top View Main Module; Figure 7-2: Location Of Jumpers - Bottom View Main Module - evertz 7812UDXD Series Manual

7.

JUMPERS

Figure 7-1 and Figure 7-2 provide the locations of the jumpers and LEDs on the 7812UDXD series
boards.
J7
MODULE
STATUS Serial
Upgrade
J2
Run
Figure 7-2: Location of Jumpers – Bottom View Main Module
7.1. SELECTING WHETHER LOCAL FAULTS WILL BE MONITORED BY THE GLOBAL FRAME
STATUS
FRAME STATUS: The FRAME STATUS jumper J2 is located near the rear of the board and close to
the white metal connector. The FRAME STATUS jumper determines whether local
faults (as shown by the Local Fault indicator) will be connected to the 7700FR-C or
7800FR frame's global status bus.
To monitor faults on this module with the frame status indicators (on the PS FRAME
STATUS LED's and on the Frame's Fault Tally output) install this jumper in the On
position. (Default)
When this jumper is installed in the Off position, local faults on this module will not
be monitored.
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Figure 7-1: Location of Jumpers – Top View Main Module
7800/7700 MultiFrame Manual
Revision 1.1.1
OFF FRAME
J2
STATUS
ON
1
ON
Page - 187