Selecting Whether Local Faults Will Be Monitored By The Global Frame Status; Configuring The Module For Firmware Upgrades - evertz 7700 Manual

7700 MultiFrame Manual
7700SID(-AM) Source Identification Decoder
6.1. SELECTING WHETHER LOCAL FAULTS WILL BE MONITORED
BY THE GLOBAL FRAME STATUS
FRAME STATUS The FRAME STATUS jumper J22 located at the front of the module determines
whether local faults (as shown by the Local Fault indicator) will be connected to the
7700FR frame's global status bus. (This feature is not available on Rev 1 versions
of the board)
To monitor faults on this module with the frame status indicators (on the PS FRAME
STATUS LED's and on the Frame's Fault Tally output) install this jumper. (Default)
When this jumper is removed, local faults on this module will not be monitored. For
convenience you may re-install the jumper so that only one side is connected.
6.2.

CONFIGURING THE MODULE FOR FIRMWARE UPGRADES

UPGRADE The UPGRADE jumper J16 located at the front of the module is used when firmware
upgrades are being done to the module. For normal operation it should be installed
in the RUN position. On Rev 1 versions of this board the upgrade jumper is located
in another location. See the Upgrading Firmware section of this manual for more
information.
To upgrade the firmware in the module unit pull it out of the frame. Move Jumper
J16 into the UPGRADE position. Install the Upgrade cable provided (located in the
vinyl pouch in the front of this manual) onto header J24 at the card edge. Re-install
the module into the frame.
Firmware section of this manual. Once the upgrade is completed, remove the
module from the frame, move J16 into the RUN position, remove the upgrade cable
and re-install the module. The module is now ready for normal operation.
7700SID(-AM)-26
Run the upgrade as described in the Upgrading
Revision 0.3