evertz 7812UDXD Series Manual page 37

GPIO1 – 4 - Configuration for defining the four (4) card GPIOs as a GPI or a GPO
and further defining the function of each GPIO.
GPIO5 – 8 - Configuration for defining the four (4) card GPIOs as a GPI or a GPO
and further defining the function of each GPIO.
GPIO Control
GPIO9 – 12 - Configuration for defining the four (4) card GPIOs as a GPI or a GPO
and further defining the function of each GPIO.
GPIO13 – 16 - Configuration for defining the four (4) card GPIOs as a GPI or a GPO
and further defining the function of each GPIO.
Configuration for cueing, playing and looping embedded side panel logos. Logo
Panel Logo
status is also reported in this control tab.
Configuration for defining the IP address, subnet mask and default gateway for the
card's Ethernet port. At the time of this manual's writing the Ethernet port is only
IP
used for uploading side panel content to the card's internal compact flash and for
use with a mini-agent for VistaLINK
Configures high-level Dolby Metadata encoder parameters including output line, DID,
Dolby Metadata
SDID, program configuration and encoding type (Method A or Method B).
Dolby Metadata
Configuration used to define the Dolby Metadata source and program dialnorms.
Adjust
Configuration used to define the Dolby Metadata Presets including Dolby Metadata
Dolby Metadata
Preset Source, Dolby Metadata Present Preset Trigger, Dolby Metadata Missing
Presets
Trigger and Program Config Assert and De-Assert controls.
Program 1&2, 3&4, 5&6, 7&8 - Configures the Dolby Metadata Encoder for
Program 1&2, 3&4, 5&6, 7&8, including bitstream modes, center mix level, surround
Dolby Metadata
mix level, surround modes, dial norm function, room type, copyrighting, down mix
Author configurations, Dolby surround EX control, DC filter LFE lowpass filter Surround
Phase shifting surround attenuation RF overmod protect, RF mode line mode and
Audio Coding Mode.
The 7812UDXD series module can decode Dolby AC3 and Dolby E with the Dolby
Decode options. There can be up to two Dolby decode modules.
Dolby Decoder
Control Decoder A and B – Configurations for Dolby decoder controls, including decoder
(+DD or +DD2) source from incoming AES or DMX audio. Video sync sources, Dolby delay
compensation, Dolby switch suppression, user preset recalls on present/missing
incoming Dolby and Dolby audio channel delay.
Dolby E Encoder Encoder A/B – The Dolby E Encoder control tab contains the configurations for
Control
Dolby encoder line phase adjustments, Auto program configuration delay
(+DEE Only) compensation and data width.
Encoder A/B – Both Dolby E Mixer controls for +DDE and +DDE2 can be controlled
Dolby E Encoder
from this tab. The displayed configurations will be for the selected radial button. If
Mixer
the radio button is grayed out this option is not installed.
(+DEE and/or
Ch1 – Ch4/Ch5 – Ch8 - All selectable options under "Source X" and "Source Y",
+DEE2 Only)
channel gain controls, and channel inversion.
Encoder A/B – The Dolby AC3 Encoder control tab contains the configurations for
Dolby AC3
auto mode program, metadata program selection AC-3 bitrate control Final ACMOD
Encoder Control
and delay compensation.
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Revision 1.1.1
7800/7700 MultiFrame Manual
.
®
Page - 23