5.
JUMPERS AND USER ADJUSTMENTS
Toggle
switch
J9
J11 J12
J13
J14
RF Input High
Local Fault / Module OK
RF Input OK
Dot Matrix
Display
RF Input Low
RF Output High
Pushbutton
RF Output OK
RF Output Low
Dip Switch
POWER
J10
GND
+12V
Figure 5-1: Jumper/LED Locations for Rev 1 7703DA4/8-RF Cards
J9
J11 J12
J13
J14
Local Fault / Module OK
POWER
J10
GND
+12V
Figure 5-2: Jumper / LED Locations for Rev 1 7702DA4/8-RF Cards
5.1.
SELECTING WHETHER LOCAL FAULTS WILL BE MONITORED
BY THE GLOBAL FRAME STATUS
The FRAME STATUS jumper J9, located at the front of the module determines whether local faults (as
shown by the Local Fault indicator) will be connected to the 7700FR frame's global status bus.
To monitor faults on this module with the frame status indicators (on the PS FRAME
FRAME STATUS:
STATUS LED's and on the Frame's Fault Tally output) install this jumper in the On
position. On Rev 1 and A boards install the jumper. (default)
RF Shield
EVERTZ 7700DA-RF
RF Shield
EVERTZ 7700DA-RF
Revision 1.3
7700 MultiFrame Manual
7702/7703DA4/8-RF Active Splitters
7702/7703DA4/8-RF - 9