Table of Contents
Advertisement
6.3.
VIDEO MONITOR TAB
The Video Monitor section enables the user to view the status of video related parameters. The following
sections describe the monitoring in greater detail.
6.3.1. Video Monitor
6.3.1.1.
PGM IN A BNC Vid Std
The Main PGM IN BNC Video Std reports if a valid video signal is presented to PGM IN A and what
standard has been detected when it is present.
6.3.1.2.
PGM IN B BNC Vid Std
The Backup PGM IN BNC Video Std reports if a valid video signal is presented to PGM IN B and what
standard has been detected when it is present.
6.3.1.3.
Input Video BNC
The Input Video BNC reports what input BNC has been selected to pass through the main up/down/cross
conversion path.
6.3.1.4.
Reference Status
The Reference Status is used to see where the current valid reference standard is being applied to the
module. When no reference is detected, the Reference Status window will state None.
6.3.1.5.
External Genlock Video Standard
The External Genlock Video Standard monitor is used to determine what type of genlock standard is
being applied to the input reference BNC reported by the Reference Status monitor.
6.3.1.6.
Video Payload ID
The Video Payload ID reports if a valid Video Payload ID ANC packet has been detected and will display
the decoded video format information.
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Figure 6-2: Video Monitor Tab
Revision 1.1.1
7800/7700 MultiFrame Manual
Page - 33
Advertisement
Table of Contents
