evertz 7812UDXD Series Manual page 39

Channels L, R, C, LFE - Configuration for channel swapping, audio gain, audio
inversion and mono mixing for outbound audio channels Left, Right center and Low
frequency effect.
UpMix Mixer
Channels Ls, Rs, Stereo Left, Stereo Right - Configuration for channel swapping,
audio gain, audio inversion and mono mixing for outbound audio channels left
surround, right surround, Stereo PassThru left and stereo PassThru Right.
Intelligain Configuration used to set up the IntelliGain controls including Program Configuration
Configuration Source, Content Attack and Release times, Compander Attack and Release Times
and IntelliGain Audio Sources.
(+IG Only)
Channels 1 - 4 - Configuration for channel swapping, audio gain, audio inversion
and mono mixing for outbound audio channels CH1, CH2, CH3, CH4.
Intelligain Mixer
Channels 5 - 8 - Configuration for channel swapping, audio gain, audio inversion
and mono mixing for outbound audio channels CH5, CH6, CH7, CH8.
As IntelliGain detects valid audio programs, the VistaLINK
tabs will become activated. The user interface and program configuration tabs are
identical.
IntelliGain
Program Control
IG-Program 1, 2, 3, 4, 5, 6, 7, 8 – Configures the IntelliGain Program 1, 2, 3, 4, 5,
6, 7, 8 settings, including Intelligain state, Leveler Controls, Compander controls,
Peak limiter, Maximum Gain, threshold settings and Monitoring.
IntelliGain Traps The IntelliGain Traps are used to alert VistaLINK
(+IG Only) and Critical loudness for each of the IntelliGain programs.
AVM Control AVM Control – Configurations for setting the audio silence level and duration.
AVM Presets – Configurations for asserting and de-asserting Presets on audio
AVM Presets
silence.
AVM Traps – Controls for reporting audio silent traps back to VLPro on a by channel
AVM Traps
basis.
Audio/Video Configuration for enabling and disabling specific Video and Audio fault traps and
viewing Video and Audio trap status.
Traps
Configuration for enabling and disabling specific Close Captioning fault traps and
CC Fault Traps
viewing Close Captioning trap status.
Thumbnails – Configurations for thumbnail controls including Thumbnail transfer
Thumbnails
enable/disable, thumbnail size, and server IP address.
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Revision 1.1.1
7800/7700 MultiFrame Manual
program configuration
®
of all the traps for Minor, Major
®
Page - 25