6.Metadata Source Select; 7.Metadata Reversion Mode - evertz 7812UDXD Series Manual

7800/7700 MultiFrame Manual
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
6.35.1.6. Metadata Source Select
The Metadata Source Select is used to select the metadata source that controls the Dolby E Encoder. A
full list of available options is listed below.
Dolby Decoder A
Dolby Decoder B
External Input 1
VANC Input 1
VANC Input 2
Metadata Adjust A
Metadata Adjust B
Metadata Author A
Metadata Author B
Automatic
6.35.1.7. Metadata Reversion Mode
The Metadata Reversion Mode is used if metadata is lost on the primary source. With this control, you
can select the backup (reversion) metadata source in case the primary source is lost or in error. A full list
of available options is listed below.
Page - 128
Select the Dolby Decoder A to use the metadata decoded
by the on-card Dolby Decoder. If PCM is provided to the
Dolby Decoder, a default 4x2 Dolby-E metadata message is
generated.
Select the Dolby Decoder B to use the metadata decoded
by the on-card Dolby Decoder. If PCM is provided to the
Dolby Decoder, a default 4x2 Dolby-E metadata message is
generated.
Select External Input 1 to use external metadata provided
on the DB-15 AES In connector.
Select VANC Input 1 to use metadata de-embedded from
VANC area of video.
Select VANC Input 2 to use metadata de-embedded from
VANC area of video.
Select Metadata Adjust A to use the output of the metadata
monitor/processor block.
Select Metadata Adjust B to use the output of the metadata
monitor/processor block.
Select Metadata Authoring A to use the output of the on-
card metadata authoring tool.
Select Metadata Authoring B to use the output of the on-
card metadata authoring tool
Select Automatic (Default) to use the selected automatic
default configuration
Revision 1.1.1