4.Dolby Metadata Vanc Sdid; 5.Method Control; External Output; 1.External Output Metadata Source Select - evertz 7812UDXD Series Manual

6.28.2.4. Dolby Metadata VANC SDID
This control sets the output SDID for the Dolby Metadata ancillary data packets. To adjust the control,
drag the slider right to increase the value and left to decrease the value. The SDID Control value ranges
from 0x1 to 0xFF. The default value is 0x1.
6.28.2.5. Method Control
This control enables the user to set the method that is used for Dolby Metadata formatting. There are two
methods for Dolby Metadata insertion as outlined in SMPTE standard SMPTE 2020. These two methods
are called Method A and Method B. Using the drop down menu, the user can set the Method to A or B for
Dolby Metadata insertion.
Method A
Method B

6.28.3. External Output

6.28.3.1. External Output Metadata Source Select
This control allows the user to select the source of Metadata that is to be outputted on the external
Metadata output. A full list of controls is shown below.
Dolby Decoder A
or B
External Input 1
VANC Input 1 or
2
Metadata Adjust
A or B
Metadata Author
A or B
7812UDXD Series 3G/HD Up/Down/Cross Converter with Simultaneous Dual Format Outputs and AES I/O
Use SMPTE 2020 Method A process for Dolby Metadata insertion.
Use SMPTE 2020 Method B process for Dolby Metadata insertion.
Dolby Metadata External output will be sourced by either decoder A or
decoder B.
Dolby metadata External output will be sourced by the external
Metadata input on the rear-plate.
Dolby Metadata External output will be sourced by the incoming VANC
source 1 or 2.
Dolby metadata External output will be sourced by the Metadata Adjust
Tab through the A or B metadata adjust controls.
Dolby metadata External output will be sourced by the Metadata Author
tab in either the Metadata Author A or B controls.
Revision 1.1.1
7800/7700 MultiFrame Manual
Page - 91