5.11.2. Upgrade
UTILITIES
UPGRADE
YES,
CANCEL
5.11.3. Factory Reset
UTILITIES
FACTORY
RESET
YES,
CANCEL
5.11.4. Show Font (Debug mode only)
6.
JUMPERS
EVERTZ (A) 7700PB2
MODULE STATUS
SIGNAL PRESENT
AUDIO Run
J16
Upgrade
FRAME
STATUS
ON
OFF
J22
Figure 3 : Location of Jumpers on Rev A 7700PB2 Boards
Command to initiate an upgrade of the application software
In addition to the software upgrade support detailed in this manual (See
the Upgrading Firmware section of this manual for more information), you
can initiate an upgrade with this command. This will allow you upgrade
the software without unplugging the card and changing the upgrade
jumper.
After selecting the upgrade operation, you must change the command to
"yes" and press the push button before the upgrade can take place.
After the upgrade has finished, the unit will automatically start and run in
normal operating mode.
Command to restore all controls back to their factory defaults
After selecting the reset operation, you must change the command to
"yes" and press the push button before the command takes place. After
the command, all parameters will be set to their factory default.
Revision 0.3
7700SID(-AM) Source Identification Decoder
+12V
SFF POWER
7700 MultiFrame Manual
7700SID(-AM)-25