Factory Default; Custom Default - ZyXEL Communications XS3800-28 User Manual

Fig ure 422
3
If you want to access the Switch Web Configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).
58.2.5 Fa c to ry De fa ult
Follow the steps below to reset the Switch back to the factory defaults.
1
Click the
Fa c to ry De fa ult
2
Click to continue or
O K
Fig ure 423
If you want to access the Switch Web Configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1 or DHCP-
assigned IP).
58.2.6 C usto m De fa ult
Follow the steps below to reset the Switch back to the
This will save the custom default configuration settings to both
1
Click the
C usto m De fa ult
2
Click to continue or
O K
Note: If you did not save a
running-config custom-default, then the factory default file is restored after you
press click
make all your configurations again on the Switch.
Chapter 58 Maintenance
Load Stacking Default: Start
button.
to abort.
C a nc e l
Load Factory Default: Confirmation
button.
to abort.
C a nc e l
C usto m De fa ult
C usto m De fa ult
XS3800-28 User's Guide
C usto m De fa ult
file in the Web Configurator or CLI using copy
(next to
Re b o o t Syste m
528
configuration file you created.
and
C o nfig ura tio n 1 C o nfig ura tio n 2
) on the Switch. You will then have to
.