ZyXEL Communications XS3800-28 User Manual page 233

Advanced Application > Port Authentication > Compound Authentication Mode (Stacking
Fig ure 178
Mode)
The following table describes the labels in this screen.
Table 84 Advanced Application > Port Authentication > Compound Authentication Mode
L ABEL DESC RIPT IO N
SLOT This field appears only in stacking mode. Click the drop-down list to choose the slot number of
the Switch in a stack.
Port This field displays the port number. In stacking mode, the first number represents the slot ID and
the second is the port number. Please note that the default stacking ports (the last four ports of
your Switch) cannot be configured. They are reserved for stacking only.
* Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Compound Specify how the Switch authenticates clients for network access.
Authentication
Select
Mode
authentication AND MAC authentication at the same time.
Select
OR MAC authentication.
Apply Click
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Chapter 18 Port Authentication
to allow network access to clients only when clients passes IEEE 802.1x
Stric t
to allow network access to clients when clients passes IEEE 802.1x authentication
L o o se
to save your changes to the Switch's run-time memory. The Switch loses these
to begin configuring this screen afresh.
XS3800-28 User's Guide
233
link on the top navigation panel to
Sa ve