Static Arp - ZyXEL Communications XS3800-28 User Manual

Table 243 IP Application > ARP Setup > ARP Learning (continued)
L ABEL
ARP Learning
Mode
Apply
Cancel
57.2.2 Sta tic ARP
Use this screen to create static ARP entries that will display in the
will not age out. Click the link next to
screen as shown.
Fig ure 417
Fig ure 418
Chapter 57 ARP Setup
DESC RIPT IO N
Select the ARP learning mode the Switch uses on the port.
Select to have the Switch update the ARP table only with the ARP replies to the ARP
ARP- Re ply
requests sent by the Switch.
Select
G ra tuito us- ARP
gratuitous ARP request.
Select to have the Switch update the ARP table with both ARP replies, gratuitous
ARP- Re q ue st
ARP requests and ARP requests.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
IP Application > ARP Setup > Static ARP (Standalone Mode)
IP Application > ARP Setup > Static ARP (Stacking Mode)
XS3800-28 User's Guide
to have the Switch update its ARP table with either an ARP reply or a
in the
Sta tic ARP IP Applic a tio n
522
link on the top navigation panel to save
Sa ve
>
Ma na g e m e nt ARP T a b le
> screen to display the
ARP Se tup
screen and