ZyXEL Communications XS3800-28 User Manual page 603

Management > Port Status > DDMI > DDMI Details
Fig ure 482
The following table describes the labels in this screen.
Table 287 Management > Port Status > DDMI > DDMI Details
L ABEL DESC RIPT IO N
Transceiver Information
Port No This identifies the SFP port. In stacking mode, the first number represents the slot and the
second the port number.
Connector Type This displays the connector type of the optical transceiver.
Vendor This displays the vendor name of the optical transceiver.
Part Number This displays the part number of the optical transceiver.
Serial Number This displays the serial number of the optical transceiver.
Revision This displays the revision number of the optical transceiver.
Date Code This displays the date when the optical transceiver was manufactured.
Transceiver This displays details about the type of transceiver installed in the SFP slot.
Calibration This field is available only when an SFP transceiver is inserted into the SFP slot.
Inte rna l
if the measurement values are raw data which the Switch calibrates.
DDMI Information
Type This displays the DDMI parameter.
Temperature This displays the temperature inside the SFP transceiver in degrees Celsius or Fahrenheit.
(C/F)
Voltage (V) This displays the level of voltage being supplied to the SFP transceiver.
TX Bias (mA) This displays the milliamps (mA) being supplied to the SFP transceiver's Laser Diode Transmitter.
TX Power This displays the amount of power the SFP transceiver is transmitting.
(dbm)
RX Power This displays the amount of power the SFP transceiver is receiving from the fiber cable.
(dbm)
Current This displays the current status for each monitored DDMI parameter.
Chapter 71 Port Status
displays if the measurement values are calibrated by the transceiver.
XS3800-28 User's Guide
603
displays
Exte rna l