ZyXEL Communications XS3800-28 User Manual page 567

Management > Diagnostic (Stacking Mode)
Fig ure 456
The following table describes the labels in this screen.
Table 268 Management > Diagnostic
L ABEL DESC RIPT IO N
Ping Test
IPv4 Select this option if you want to ping an IPv4 address, and select which traffic flow (
or
o ut- o f- b a nd
If you select
(labeled
If you select
MG MT
Otherwise, select
IPv6 Select this option if you want to ping an IPv6 address. You can also select
the ID number of the VLAN to which the Switch is to send ping requests. Otherwise, select
send ping requests to all VLANs on the Switch.
IP Address/Host Type the IP address or host name of a device that you want to ping in order to test a
Name
connection.
Click
Source IP Type the source IP address that you want to ping in order to test a connection.
Address
Click
Count Enter the number of ICMP Echo Request (ping) messages the Switch continuously sends.
Chapter 60 Diagnostic
) the Switch is to send ping frames.
, the Switch sends the frames to all ports except the management port
in- b a nd
).
MG MT
, the Switch sends the frames to the management port (labeled
o ut- o f- b a nd
).
to send ping requests to all VLANs on the Switch.
–
to have the Switch ping the IP address.
Ping
to have the Switch ping the IP address.
Ping
XS3800-28 User's Guide
567
in- b a nd
and specify
vla n
to
–