Service Access Control - ZyXEL Communications XS3800-28 User Manual

Table 258 Management > Access Control > Logins (continued)
L ABEL
Password
Retype to
confirm
Privilege
Apply
Cancel
59.5 Se rvic e Ac c e ss C o ntro l
Service Access Control allows you to decide what services you may use to access the Switch. You may
also change the default service port and configure "trusted computers" for each service in the
Ma na g e m e nt
screen.
Management > Access Control > Service Access Control
Fig ure 441
The following table describes the fields in this screen.
Table 259 Management > Access Control > Service Access Control
L ABEL
Services
Active
Chapter 59 Access Control
DESC RIPT IO N
Enter your new system password.
Retype your new system password for confirmation.
Type the privilege level for this user. At the time of writing, users may have a privilege level of 0,
3, 13, or 14 representing different configuration rights as shown below.
• 0 – Display basic system information.
• 3 – Display configuration or status.
• 13 – Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins, administrator
and enable passwords, and configuration information display.
• 14 – Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session's privilege level is greater than or equal to the
command's privilege level. The session privilege initially comes from the privilege of the login
account. For example, if the user has a privilege of 5, he or she can run commands that
requires privilege level of 5 or less but not more.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
screen (discussed later). Click
DESC RIPT IO N
Services you may use to access the Switch are listed here.
Select this option for the corresponding services that you want to allow to access the Switch.
XS3800-28 User's Guide
Sa ve
to go back to the main
Ac c e ss C o ntro l
549
link on the top navigation panel to
Ac c e ss C o ntro l
Re m o te