Mld Snooping-Proxy Filtering - ZyXEL Communications XS3800-28 User Manual

The following table describes the fields in the above screen.
Table 110 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > VLAN > Port Role
Setting
L ABEL
MLD Snooping-proxy
VLAN ID
SLOT
Port
*
Port Role
Leave Mode
Leave Timeout
Fast Leave Timeout
Apply
Cancel
25.4.4 ML D Sno o ping - pro xy Filte ring
Use this screen to configure the Switch's MLD filtering settings. Click the
Applic a tio n
Chapter 25 Multicast
DESC RIPT IO N
Select the VLAN ID for which you want to configure a port's MLD snooping-proxy settings.
This field appears only in stacking mode. Click the drop-down list to choose the slot
number of the Switch in a stack.
This field displays the port number. In stacking mode, the first number represents the slot
ID and the second is the port number. Please note that the default stacking ports (the
last four ports of your Switch) cannot be configured. They are reserved for stacking only.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first
to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
A port on the Switch can be either a
downstream port connects to MLD hosts and acts as a multicast router to send MLD
queries and listen to the MLD host's Report and Done messages. An upstream port
connects to a multicast router and works as a host to send Report or Done messages
when receiving queries from a multicast router.
Otherwise, select
this VLAN.
Select the leave mode for the specified downstream ports in this VLAN.
This specifies whether the Switch removes an MLD snooping membership entry (learned
on a downstream port) immediately (
leave timeout (
received on this port from a host.
Enter the MLD snooping normal leave timeout (in milliseconds) the Switch uses to update
the forwarding table for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Enter the fast leave timeout (in milliseconds) for the specified downstream ports.
This defines how many seconds the Switch waits for an MLD report before removing an
MLD snooping membership entry (learned on a downstream port) when an MLD Done
message is received on this port from a host.
Click to save your changes to the Switch's run-time memory. The Switch loses
Apply
these changes if it is turned off or loses power, so use the
panel to save your changes to the non-volatile memory when you are done configuring.
Click to reset the fields to your previous configuration.
C a nc e l
> >
Multic a st IPv6 Multic a st
XS3800-28 User's Guide
Do wnstre a m
if the port is not joining a multicast group or does not belong to
No ne
Im m e dia te
) or fast leave timeout (
No rm a l
>
ML D Sno o ping - pro xy
285
port or port in MLD. A
Upstre a m
) or wait for an MLD report before the
) when an MLD leave message is
Fa st
link on the top navigation
Sa ve
link in the
Filte ring
screen to display the screen as shown.
Adva nc e d