ZyXEL Communications XS3800-28 User Manual page 145

Advanced Application > VLAN > VLAN Configuration > Subnet Based VLAN Setup
Fig ure 109
The following table describes the labels in this screen.
Table 50 Advanced Application > VLAN > VLAN Configuration > Subnet Based VLAN Setup
L ABEL DESC RIPT IO N
Active Check this box to activate this subnet based VLANs on the Switch.
DHCP-Vlan When DHCP snooping is enabled DHCP clients can renew their IP address through the DHCP
Override VLAN or via another DHCP server on the subnet based VLAN.
Select this check box to force the DHCP clients in this IP subnet to obtain their IP addresses
through the DHCP VLAN.
Apply Click
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Active Check this box to activate the IP subnet VLAN you are creating or editing.
Name Enter up to 32 alpha numeric characters to identify this subnet based VLAN.
IP Enter the IP address of the subnet for which you want to configure this subnet based VLAN.
Mask-Bits Enter the bit number of the subnet mask. To find the bit number, convert the subnet mask to
binary format and add all the 1's together. Take "255.255.255.0" for example. 255 converts to
eight 1s in binary. There are three 255s, so add three eights together and you get the bit
number (24).
VID Enter the ID of a VLAN with which the untagged frames from the IP subnet specified in this
subnet based VLAN are tagged. This must be an existing VLAN which you defined in the
Adva nc e d Applic a tio n
Priority Select the priority level that the Switch assigns to frames belonging to this VLAN.
Add Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it
is turned off or loses power, so use the
changes to the non-volatile memory when you are done configuring.
Cancel Click
Index This is the index number identifying this subnet based VLAN. Click on any of these numbers to
edit an existing subnet based VLAN.
Chapter 9 VLAN
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
> >
VL AN
to begin configuring this screen afresh.
C a nc e l
XS3800-28 User's Guide
145
link on the top navigation panel to
Sa ve
screen.
Sta tic VL AN
link on the top navigation panel to save your
Sa ve