ZyXEL Communications XS3800-28 User Manual page 150

Advanced Application > VLAN > VLAN Configuration > Voice VLAN Setup
Fig ure 114
The following table describes the fields in the above screen.
Table 52 Advanced Application > VLAN > VLAN Configuration > Voice VLAN Setup
L ABEL DESC RIPT IO N
Voice VLAN Global Setup
Voice VLAN Click the second radio button if you want to enable the Voice VLAN feature. Type a
VLAN ID number in the box next to the radio button that is associated with the Voice
VLAN. You also need to create a static VLAN with the same VID in the
screen, and then connect the IP phone with the specified OUI MAC address to a port
that joins the static VLAN.
Click
Priority Select the priority level of the voice traffic from 0 to 7. Default setting is 5. The higher the
numeric value you assign, the higher the priority for this voice traffic.
Apply Click
changes if it is turned off or loses power, so use the
to save your changes to the non-volatile memory when you are done configuring.
Cancel Click
Clear Click
Voice VLAN OUI Setup
OUI address Enter the IP phone manufacturer's OUI MAC address. The first 3 byes is the manufacturer
identifier, the last 3 bytes is a unique station ID.
OUI mask Enter the mask for the specified IP phone manufacturer's OUI MAC address to determine
which bits a packet's MAC address should match.
Enter "f" for each bit of the specified MAC address that the traffic's MAC address should
match. Enter "0" for the bits of the matched traffic's MAC address, which can be of any
hexadecimal characters. For example, if you set the MAC address to 00:13:49:00:00:00
and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56
matches this criteria.
Description Enter a description up to 32 characters for the Voice VLAN device. For example: Siemens.
Add Click
changes if it is turned off or loses power, so use the
to save your changes to the non-volatile memory when you are done configuring.
Chapter 9 VLAN
radio button if you do not want to enable the Voice VLAN feature.
Disa b le
to save your changes to the Switch's run-time memory. The Switch loses these
Apply
to begin configuring this section afresh.
C a nc e l
to reset the fields to default settings.
C le a r
to save your changes to the Switch's run-time memory. The Switch loses these
Add
XS3800-28 User's Guide
150
Sta tic VL AN Se tup
link on the top navigation panel
Sa ve
link on the top navigation panel
Sa ve