ZyXEL Communications XS3800-28 User Manual page 327

.
C o nfig ure
Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Fig ure 242
Configure
The following table describes the labels in this screen.
Table 135 Advanced Application > IP Source Guard > IPv4 Source Guard Setup > ARP Inspection >
Configure
L ABEL DESC RIPT IO N
Active Select this to enable ARP inspection on the Switch. You still have to enable ARP inspection
on specific VLAN and specify trusted ports.
Filter Aging Time
Filter aging time This setting has no effect on existing MAC address filters.
Enter how long (1 – 2147483647 seconds) the MAC address filter remains in the Switch after
the Switch identifies an unauthorized ARP packet. The Switch automatically deletes the
MAC address filter afterwards. Type 0 if you want the MAC address filter to be permanent.
Log Profile
Log buffer size Enter the maximum number (1 – 1024) of log messages that were generated by ARP packets
and have not been sent to the syslog server yet. Make sure this number is appropriate for
the specified
If the number of log messages in the Switch exceeds this number, the Switch stops recording
log messages and simply starts counting the number of entries that were dropped due to
unavailable buffer. Click
clear the log and reset this counter.
Syslog rate Type the maximum number of syslog messages the Switch can send to the syslog server in
one batch. This number is expressed as a rate because the batch frequency is determined
by the
want the Switch to send log messages generated by ARP packets to the syslog server.
The relationship between
•
•
Log interval Type how often (1 – 86400 seconds) the Switch sends a batch of syslog messages to the
syslog server. Enter 0 if you want the Switch to send syslog messages immediately. See
ra te
Chapter 29 ARP Inspection
and
Syslo g ra te L o g inte rva l
C le a ring lo g sta tus ta b le
. You must configure the syslog server to use this. Enter 0 if you do not
L o g Inte rva l
Syslo g ra te
Four invalid ARP packets per second,
syslog messages every second.
Six invalid ARP packets per second,
syslog messages every 2 seconds.
for an example of the relationship between
XS3800-28 User's Guide
327
.
in the
ARP Inspe c tio n L o g Sta tus
and is illustrated in the following examples:
L o g inte rva l
is 5,
Syslo g ra te L o g inte rva l
is 5,
Syslo g ra te L o g inte rva l
and
Syslo g ra te
screen to
is 1: the Switch sends 4
is 2: the Switch sends 5
Syslo g
.
L o g inte rva l