Dscp-To-Ieee 802.1P Priority Settings; Configuring Dscp Settings - ZyXEL Communications XS3800-28 User Manual

Table 219 IP Application > DiffServ (continued)
L ABEL
Active
Apply
Cancel
53.3 DSC P- to - IEEE 802.1p Prio rity Se tting s
You can configure the DSCP to IEEE 802.1p mapping to allow the Switch to prioritize all traffic based on
the incoming DSCP value according to the DiffServ to IEEE 802.1p mapping table.
The following table shows the default DSCP-to-IEEE802.1p mapping.
Table 220 Default DSCP-IEEE 802.1p Mapping
DSCP VALUE
IEEE 802.1p
53.3.1 C o nfig uring DSC P Se tting s
To change the DSCP-IEEE 802.1p mapping click the
screen as shown next.
IP Application > DiffServ > DSCP Setting
Fig ure 380
The following table describes the labels in this screen.
Table 221 IP Application > DiffServ > DSCP Setting
L ABEL DESC RIPT IO N
0 ... 63 This is the DSCP classification identification number.
To set the IEEE 802.1p priority mapping, select the priority level from the drop-down list box.
Chapter 53 Differentiated Services
DESC RIPT IO N
Select to enable Diffserv on the port.
Ac tive
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
0 – 7 8 – 15 16 – 23
0 1 2
XS3800-28 User's Guide
link on the top navigation panel to save
Sa ve
24 – 31 32 – 39 40 – 47
3 4 5
link in the
DSC P Se tting
485
48 – 55 56 – 63
6 7
screen to display the
DiffSe rv