Static Routing; Ipv4 Static Route - ZyXEL Communications XS3800-28 User Manual

47.2 Sta tic Ro uting
Click
IP Applic a tio n
Click the link next to
Click the link next to
Fig ure 349
47.3 IPv4 Sta tic Ro ute
Click the link next to
as shown.
Fig ure 350
The following table describes the related labels you use to create a static route.
Table 199 IP Application > Static Routing > IPv4 Static Route
L ABEL
Active
Name
Destination IP
Address
IP Subnet Mask
Gateway IP
Address
Chapter 47 Static Route
>
Sta tic Ro uting
IPv4 Sta tic Ro ute
IPv6 Sta tic Ro ute
IP Application > Static Routing
IPv4 Sta tic Ro ute
IP Application > Static Routing > IPv4 Static Route
DESC RIPT IO N
This field allows you to activate or deactivate this static route.
Enter a descriptive name (up to 10 printable ASCII characters) for identification purposes.
This parameter specifies the IP network address of the final destination.
Enter the subnet mask for this destination. Routing is always based on network number. If you
need to specify a route to a single host, use a subnet mask of 255.255.255.255 in the subnet mask
field to force the network number to be identical to the host ID.
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination. The gateway must be a router on the same segment
as your Switch.
XS3800-28 User's Guide
in the navigation panel to display the screen as shown.
to open a screen where you can create IPv4 static routing rules.
to open a screen where you can create IPv6 static routing rules.
in the >
IP Applic a tio n
449
screen to display the screen
Sta tic Ro uting