Viewing Vrrp Summary - ZyXEL Communications XS3800-28 User Manual

Table 240 IP Application > VRRP Configuration: VRRP Parameters (continued)
L ABEL
Virtual Router ID
Advertisement Interval Specify the number of seconds between Hello message transmissions. The default is
Preempt Mode
Priority
Uplink Gateway
Response Ping
Primary Virtual IP
Secondary Virtual IP
Add
Cancel
Clear
55.3.4 Vie wing VRRP Sum m a ry
View the VRRP configuration summary at the bottom of the screen.
IP Application > VRRP Configuration: Summary
Fig ure 402
The following table describes the labels in this screen.
Table 241 IP Application > VRRP Configuration: Summary
L ABEL
Index
Active
Name
Network
VRID
Primary VIP
Uplink Gateway
Priority
Chapter 55 VRRP
DESC RIPT IO N
Select a virtual router number (1 to 7) for which this VRRP entry is created.
You can configure up to seven virtual routers for one network.
Select this option to activate preempt mode.
Enter a number (between 1 and 254) to set the priority level. The bigger the number, the
higher the priority.
This field is by default.
100
Enter the IP address of the uplink gateway in dotted decimal notation.
The Switch checks the link to the uplink gateway.
Select this option to have the Switch respond to a ping that is sent to the virtual IP address.
Enter the IP address of the primary virtual router in dotted decimal notation.
This field is optional. Enter the IP address of a secondary virtual router in dotted decimal
notation. This field is ignored when you enter
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if
it is turned off or loses power, so use the
changes to the non-volatile memory when you are done configuring.
Click to discard all changes made in this table.
C a nc e l
Click to set the above fields back to the factory defaults.
C le a r
DESC RIPT IO N
This field displays the index number of an entry. Click an index number to change the settings.
This field shows whether a VRRP entry is enabled (
This field displays a descriptive name of an entry.
This field displays the IP address and subnet mask of an interface.
This field displays the ID number of a virtual router.
This field displays the IP address of the primary virtual router.
This field displays the IP address of the uplink gateway.
This field displays the priority level (1 to 255) of the entry.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
XS3800-28 User's Guide
0.0.0.0
link on the top navigation panel to save your
Sa ve
) or disabled (
Ye s
511
.
).
No
.
1