Anti-Arpscan Trust Host; Anti-Arpscan Configure - ZyXEL Communications XS3800-28 User Manual

41.4 Anti- Arpsc a n T rust Ho st
Use this screen to create or remove trusted hosts identified by IP address and subnet mask.
is not performed on trusted hosts. To open this screen, click
.
Ho st
Fig ure 325
The following table describes the fields in the above screen.
Table 186 Advanced Application > Anti-Arpscan > Trust Host
L ABEL
Name
Host IP
Mask
Add
Cancel
Clear
Index
Name
Host IP
Mask
Delete
Cancel
41.5 Anti- Arpsc a n C o nfig ure
Use this screen to enable
trusted or untrusted. To open this screen, click
Chapter 41 Anti-Arpscan
Advanced Application > Anti-Arpscan > Trust Host
DESC RIPT IO N
Type a descriptive name of up to 32 printable ASCII characters to identify this host.
Type the IP address of the host.
A trusted host may consist of a subnet of IP addresses. Type a subnet mask to create a
single host or a subnet of hosts.
Click this to create the trusted host.
Click this to reset the values above based or, if not applicable, to clear the fields above.
Click this to clear the fields above.
This field displays a sequential number for each trusted host.
This field displays the name of the trusted host.
This field displays the IP address of the trusted host.
This field displays the subnet mask of the trusted host.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Select an entry check box and click
Click this to clear the check boxes above.
Anti- Arpsc a n
XS3800-28 User's Guide
Adva nc e d Applic a tio n
to remove the specified entry.
De le te
, set port and host thresholds as well as configure ports to be
Adva nc e d Applic a tio n
419
Anti- a rpsc a n
>
Anti- Arpsc a n
> >
Anti- Arpsc a n C o nfig ure
>
T rust
.