Dhcpv6 Client Setup - ZyXEL Communications XS3800-28 User Manual

8.9.12 DHC Pv6 C lie nt Se tup
Use this screen to configure the Switch's DHCP settings when it is acting as a DHCPv6 client. Click the link
next to
DHC Pv6 C lie nt Se tup
Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
Fig ure 86
The following table describes the labels in this screen.
Table 37 Basic Setting > IPv6 > IPv6 Configuration > DHCPv6 Client Setup
L ABEL
Interface
IA Type
Options
Information
Refresh
Minimum
Apply
Cancel
Clear
Index
Interface
IA-NA
Rapid-Commit
DNS
Chapter 8 Basic Setting
in the
IPv6 C o nfig ura tio n
DESC RIPT IO N
Select the IPv6 interface you want to configure.
Select to set the Switch to get a non-temporary IP address from the DHCPv6 server for this
IA- NA
interface.
Optionally, you can also select
with a Rapid Commit option to obtain information from the DHCPv6 server by a rapid two-
message exchange. The Switch discards any Reply messages that do not include a Rapid
Commit option. The DHCPv6 server should also support the Rapid Commit option to have it work
well.
Select to have the Switch obtain DNS server IPv6 addresses and/or select
DNS
have the Switch obtain a list of domain names from the DHCP server.
Specify the time interval (from 600 to 4294967295 seconds) at which the Switch exchanges other
configuration information with a DHCPv6 server again.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
Click to reset the fields to the factory defaults.
C le a r
This is the interface index number. Click an index number to change the settings.
This is the name of the IPv6 interface you created.
This field displays whether the Switch obtains a non-temporary IP address from the DHCPv6 server.
This field displays whether the Switch obtains information from the DHCPv6 server by a rapid two-
message exchange.
This field displays whether the Switch obtains DNS server IPv6 addresses from the DHCPv6 server.
XS3800-28 User's Guide
screen to display the screen as shown next.
to have the Switch send its DHCPv6 Solicit message
Ra pid- C o m m it
link on the top navigation panel to save
Sa ve
121
to
Do m a in- L ist