Factory Default; Custom Default - ZyXEL Communications XS1930-12F User Manual

Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Factory Default and follow steps 1 to 2 to reboot and load Zyxel factory default configuration
settings on the Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load a customized default file on the Switch.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.

37.2.4 Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
Click the Factory Default button.
1
Click OK to continue or Cancel to abort.
2
Figure 213 Load Factory Default: Confirmation
If you want to access the Switch Web Configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1 or DHCP-
assigned IP).

37.2.5 Custom Default

Follow the steps below to reset the Switch back to the Custom Default configuration file you created.
This will save the custom default configuration settings to both Configuration 1 and Configuration 2.
Click the Custom Default button.
1
Click OK to continue or Cancel to abort.
2
Note: If you did not save a Custom Default file in the Web Configurator or CLI using copy
running-config custom-default, then the factory default file is restored after you
press click Custom Default (next to Reboot System) on the Switch. You will then have to
make all your configurations again on the Switch.
Figure 214 Load Custom Default: Confirmation
Chapter 37 Maintenance
XS1930 Series User's Guide
297