Load Factory Default; Save Configuration; Reboot System - ZyXEL Communications MES3500-24S User Manual

41.2 Load Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
In the Maintenance screen, click the Click Here button next to Load Factory Default to clear all Switch
1
configuration information you configured and return to the factory defaults.
Click OK to reset all Switch configurations to the factory defaults.
2
Figure 220 Load Factory Default: Start
In the web configurator, click the Save button in the top of the screen to make the changes take effect.
3
If you want to access the Switch web configurator again, you may need to change the IP address of
your computer to be in the same subnet as that of the default Switch IP address (192.168.1.1).

41.3 Save Configuration

Click Config 1 to save the current configuration settings permanently to Configuration 1 on the Switch.
Click Config 2 to save the current configuration settings to Configuration 2 on the Switch.
Alternatively, click Save on the top right-hand corner in any screen to save the configuration changes
to the current configuration.
Note: Clicking the Apply or Add button does NOT save the changes permanently. All
unsaved changes are erased after you reboot the Switch.

41.4 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1) or configuration two (Config 2) when you reboot. You can restart
the Switch immediately or set the Switch to restart at a specific time.
Click Management > Maintenance > Reboot System to view the screen as shown next.
Chapter 41 Maintenance
MES3500-24S/MGS3520 Series User's Guide
339