ZyXEL Communications XS3800-28 User Manual page 46

Table 4 LEDs (continued)
L ED C O L O R
CLOUD Green
Amber
Note: Hybrid mode and NCC registration are reserved for future use.
LOCATOR Blue
MAST Green
(Master)
Amber
Ethernet Ports
17 – 28 Green
Blue
SFP+ Slots
1 – 16; 21 – Green
28
Blue
MGMT Green
(Manageme (Right)
nt)
Amber
(Left)
STACK ID
Chapter 3 Hardware Panels
ST AT US DESC RIPT IO N
On The Switch has successfully connected to the NCC (Nebula Control
Center).
Blinking The Switch cannot connect to the NCC because it is not registered.
On The Switch is registered at the NCC but cannot connect to the NCC.
Please check the Internet connection of the Switch.
Blinking The Switch is not registered at the NCC and cannot connect to the NCC.
Please check the Internet connection of the Switch and register the
Switch at NCC.
Off The Switch is operating in standalone mode. Nebula Control Center
Discovery is disabled in
C e nte r Disc o ve ry
On The Switch is uploading firmware. While the Switch is doing this, do not turn
off the power.
Blinking Shows the actual location of the Switch between several devices in a
rack. The default timer is 30 minutes when you are configuring the Switch.
Off The locator is not functioning or malfunctioning.
On The Switch is acting as a standalone switch or the master in stacking.
Off The Switch is acting as a non-master member in a stack or it is in
standalone mode.
On There is an error occurred when the Switch is selected as the master
member in a stack.
On The port has a successful 100 Mbps/1 Gbps/2.5 Gbps/5 Gbps connection.
Blinking The port is receiving or transmitting data at 100 Mbps/1 Gbps/2.5 Gbps/5
Gbps.
On The port has a successful 10 Gbps connection.
Blinking The port is receiving or transmitting data at 10 Gbps.
Off This link is disconnected or the port is disabled.
On The port has a successful 1000 Mbps connection.
Blinking The port is receiving or transmitting data at 1000 Mbps.
On The port has a successful 10 Gbps connection.
Blinking The port is receiving or transmitting data 10 Gbps.
Off This link is disconnected.
On The port is connected at 10/1000 Mbps.
MG MT
Blinking The system is transmitting or receiving to or from an Ethernet device at 10/
1000 Mbps through the
On The port is connected at 100 Mbps.
MG MT
Blinking The system is transmitting or receiving to or from an Ethernet device at 100
Mbps through the
Off The port is not connected to an Ethernet device, or the port is
MG MT
disabled.
The LED is showing the Stack ID number of the Switch.
ID 0 means it is a standalone Switch.
XS3800-28 User's Guide
46
>
Ba sic C lo ud Ma na g e m e nt
in the Switch Web Configurator.
port.
MG MT
port.
MG MT
>
Ne b ula C o ntro l