Mld Snooping-Proxy Filtering Profile - ZyXEL Communications XS3800-28 User Manual

The following table describes the fields in the above screen.
Table 111 Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering
L ABEL
Active
SLOT
Port
*
Group Limit
Max Group Num.
Filtering Profile
Apply
Cancel
25.4.5 ML D Sno o ping - pro xy Filte ring Pro file
Use this screen to create an MLD filtering profile and set the range of the multicast addresses. Click the
Filte ring Pro file
screen to display the screen as shown.
Filte ring
Advanced Application > Multicast > IPv6 Multicast > MLD Snooping-proxy > Filtering >
Fig ure 215
Filtering Profile
Chapter 25 Multicast
DESC RIPT IO N
Select this option to enable MLD filtering on the Switch.
This field appears only in stacking mode. Click the drop-down list to choose the slot number
of the Switch in a stack.
This field displays the port number. In stacking mode, the first number represents the slot ID
and the second is the port number. Please note that the default stacking ports (the last four
ports of your Switch) cannot be configured. They are reserved for stacking only.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this option to limit the number of multicast groups this port is allowed to join.
Enter the number of multicast groups this port is allowed to join. Once a port is registered in
the specified number of multicast groups, any new MLD Report message is dropped on this
port.
Select the name of the MLD filtering profile to use for this port. Otherwise, select
prohibit the port from joining any multicast group.
You can create MLD filtering profiles in the
> >
Filte ring Filte ring Pro file
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to reset the fields to your previous configuration.
C a nc e l
link in the
Adva nc e d Applic a tio n
XS3800-28 User's Guide
Multic a st
screen.
Sa ve
> >
Multic a st IPv6 Multic a st
287
> >
IPv6 Multic a st ML D Sno o ping - pro xy
link on the top navigation panel to
>
ML D Sno o ping - pro xy
to
De fa ult
>