Aaa Setup - ZyXEL Communications XS3800-28 User Manual

Table 117 Advanced Application > AAA > TACACS+ Server Setup (continued)
L ABEL
Delete
Accounting
Server
Timeout
Index
IP Address
TCP Port
Shared Secret
Delete
Apply
Cancel
26.5 AAA Se tup
Use this screen to configure authentication, authorization and accounting settings on the Switch. Click
on the
AAA Se tup
Fig ure 227
DESC RIPT IO N
Check this box if you want to remove an existing TACACS+ server entry from the Switch. This
entry is deleted when you click
Use this section to configure your TACACS+ accounting settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the TACACS+ server.
This is a read-only number representing a TACACS+ accounting server entry.
Enter the IP address of an external TACACS+ accounting server in dotted decimal notation.
The default port of a TACACS+ accounting server is
your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external TACACS+ accounting server and the Switch. This key is not sent over the network. This
key must be the same on the external TACACS+ accounting server and the Switch.
Check this box if you want to remove an existing TACACS+ accounting server entry from the
Switch. This entry is deleted when you click
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
link in the screen to view the screen as shown.
AAA
Advanced Application > AAA > AAA Setup
XS3800-28 User's Guide
Chapter 26 AAA
.
Apply
Apply
300
. You need not change this value unless
49
.
link on the top navigation panel to
Sa ve