Mvr Group Configuration - ZyXEL Communications XS3800-28 User Manual

Table 113 Advanced Application > Multicast > MVR (continued)
L ABEL
*
Source Port
Receiver Port
None
Tagging
Add
Cancel
VLAN
Active
Name
Mode
Source Port
Receiver Port
802.1p
Delete
Cancel
25.5.1 MVR G ro up C o nfig ura tio n
All source ports and receiver ports belonging to a multicast group can receive multicast data sent to this
multicast group.
Use this screen to configure MVR IP multicast group addresses. Click the
screen.
MVR
Note: A port can belong to more than one multicast VLAN. However, IP multicast group
addresses in different multicast VLANs cannot overlap.
Chapter 25 Multicast
DESC RIPT IO N
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to
set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this option to set this port as the MVR source port that sends and receives multicast
traffic. All source ports must belong to a single multicast VLAN.
Select this option to set this port as a receiver port that only receives multicast traffic.
Select this option to set the port not to participate in MVR. No MVR multicast traffic is sent or
received on this port.
Select this check box if you want the port to tag the VLAN ID in all outgoing frames
transmitted.
Click this to create a new entry or to update an existing one.
This saves your changes to the Switch's run-time memory. The Switch loses these changes if it is
turned off or loses power, so use the
changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
This field displays the multicast VLAN ID. Click on an index number to change the settings.
This field displays whether the multicast group is enabled or not.
This field displays the descriptive name for this setting.
This field displays the MVR mode.
This field displays the source port numbers.
This field displays the receiver port numbers.
This field displays the priority level.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
To delete a multicast VLANs, select the rules that you want to remove, then click the
button.
Click to clear the check boxes.
C a nc e l
XS3800-28 User's Guide
291
link on the top navigation panel to save your
Sa ve
G ro up C o nfig ura tio n
De le te
link in the