Tacacs+ Server Setup - ZyXEL Communications XS3800-28 User Manual

Table 116 Advanced Application > AAA > RADIUS Server Setup (continued)
L ABEL
Shared Secret
Delete
Accounting
Server
Timeout
Index
IP Address
UDP Port
Shared Secret
Delete
Attribute
NAS-IP-Address
Apply
Cancel
26.4 T AC AC S+ Se rve r Se tup
Use this screen to configure your TACACS+ server settings. Click on the
screen to view the screen as shown.
AAA
Chapter 26 AAA
DESC RIPT IO N
Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external RADIUS server and the Switch. This key is not sent over the network. This key must be the
same on the external RADIUS server and the Switch.
Check this box if you want to remove an existing RADIUS server entry from the Switch. This entry
is deleted when you click
Apply
Use this section to configure your RADIUS accounting server settings.
Specify the amount of time in seconds that the Switch waits for an accounting request
response from the RADIUS accounting server.
This is a read-only number representing a RADIUS accounting server entry.
Enter the IP address of an external RADIUS accounting server in dotted decimal notation.
The default port of a RADIUS accounting server for accounting is
this value unless your network administrator instructs you to do so.
Specify a password (up to 32 alphanumeric characters) as the key to be shared between the
external RADIUS accounting server and the Switch. This key is not sent over the network. This key
must be the same on the external RADIUS accounting server and the Switch.
Check this box if you want to remove an existing RADIUS accounting server entry from the
Switch. This entry is deleted when you click
Use this section to define the RADIUS server attribute for its account.
Enter the IP address of the NAS (Network Access Server).
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
XS3800-28 User's Guide
.
.
Apply
Sa ve
298
. You need not change
1813
link on the top navigation panel to
T AC AC S+ Se rve r Se tup
link in the