Reboot System; Factory Default - ZyXEL Communications XS1930 Series User Manual

35.5 Reboot System

Reboot System allows you to restart the Switch without physically turning the power off. It also allows you
to load configuration one (Config 1), configuration two (Config 2), a Custom Default or Factory Default
when you reboot. Follow the steps below to reboot the Switch.
In the Maintenance screen, click a configuration button next to Reboot System to reboot and load that
1
configuration file. The following screen displays.
Figure 203 Reboot System: Confirmation
Click OK again and then wait for the Switch to restart. This takes up to two minutes. This does not affect
2
the Switch's configuration.
Click Config 1 and follow steps 1 to 2 to reboot and load configuration one on the Switch.
Click Config 2 and follow steps 1 to 2 to reboot and load configuration two on the Switch.
Click Factory Default and follow steps 1 to 2 to reboot and load default configuration settings on the
Switch.
Click Custom Default and follow steps 1 to 2 to reboot and load Custom Default configuration settings on
the Switch. This will save the custom default configuration settings to both Configuration 1 and
Configuration 2.
Note: If a customized default file was not saved, clicking Custom Default loads the factory
default configuration on the Switch.

35.5.1 Factory Default

Follow the steps below to reset the Switch back to the factory defaults.
Click the Factory Default button.
1
Click OK to continue or Cancel to abort.
2
Chapter 35 Maintenance
XS1930 Series User's Guide
283