ZyXEL Communications XS3800-28 User Manual page 59

Table 9 Navigation Panel Links (continued)
L INK DESC RIPT IO N
AAA This link takes you to a screen where you can configure authentication, authorization and
accounting services via external servers. The external servers can be either RADIUS (Remote
Authentication Dial-In User Service) or TACACS+ (Terminal Access Controller Access-Control
System Plus).
IP Source Guard This link takes you to screens where you can configure filtering of unauthorized DHCP and ARP
packets in your network.
Loop Guard This link takes you to a screen where you can configure protection against network loops that
occur on the edge of your network.
VLAN Mapping This link takes you to screens where you can configure VLAN mapping settings on the Switch.
Layer 2 Protocol This link takes you to a screen where you can configure L2PT (Layer 2 Protocol Tunneling)
Tunneling settings on the Switch.
sFlow This link takes you to screens where you can configure sFlow settings on the Switch.
PPPoE This link takes you to screens where you can configure how the Switch gives a PPPoE
termination server additional subscriber information that the server can use to identify and
authenticate a PPPoE client.
Errdisable This link takes you to a screens where you can view errdisable status and configure errdisable
settings in CPU protection, errdisable detect, and errdisable recovery.
VLAN Isolation This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
MAC Pinning This link takes you to a screen where you can set specific ports to have priority over other ports
in MAC address learning.
Private VLAN This link takes you to a screen where you can block traffic between ports in a VLAN on the
Switch.
Green Ethernet This link takes you to a screen where you can configure the Switch to reduce port power
consumption.
LLDP This link takes you to a screen where you can configure LLDP settings.
Anti-Arpscan This link takes you to screens where you can enable anti-arpscan on the Switch and ports,
and view the port state. You can also create trusted hosts, view blocked hosts and unblock
them.
BPDU Guard This link takes you to screens where you can enable BPDU guard on the Switch and ports, and
view the port state.
OAM This link takes you to screens where you can enable Ethernet OAM on the Switch, view the
configuration of ports on which Ethernet OAM is enabled and perform remote-loopback
tests.
ZULD This link takes you to screens where you can enable ZULD on a port and configure related
settings.
NLB This link takes you to screens where you can configure to which MAC addresses and ports the
Switch should forward the incoming NLB traffic, and map the IP address to the MAC address
of a cluster for layer-3 forwarding.
Wol Relay This link takes you to a screen where you can configure settings on Wake On LAN relay.
IP Application
Static Routing This link takes you to a screen where you can configure static routes. A static route defines
how the Switch should forward traffic by configuring the TCP/IP parameters manually.
Policy Routing This link takes you to screens where you can configure policy routing rules.
RIP This link takes you to a screen where you can configure the RIP (Routing Information Protocol)
direction and version for IPv4 RIP timer, and the method of preventing routing loops.
OSPF This link takes you to a screen where you can view the OSPF status and configure OSPF
settings for IPv4.
IGMP This link takes you to a screen where you can configure the IGMP settings.
Chapter 4 Web Configurator
XS3800-28 User's Guide
59