Multicast Setup; Ipv4 Multicast Status - ZyXEL Communications XS3800-28 User Manual

the Switch to leave the multicast group. The Switch sends a query to VLAN 1 on the receiver port (in this
case, an uplink port on the Switch). If there is another subscriber device connected to this port in the
same subscriber VLAN, the receiving port will still be on the list of forwarding destination for the multicast
traffic. Otherwise, the Switch removes the receiver port from the forwarding table.
Fig ure 201
25.2 Multic a st Se tup
Use this screen to configure IGMP for IPv4. Click
panel.
Fig ure 202
The following table describes the labels in this screen.
Table 102 Advanced Application > Multicast Setup
L ABEL
IPv4 Multicast
IPv6 Multicast
MVR
25.3 IPv4 Multic a st Sta tus
Click
Adva nc e d Applic a tio n
shows the IPv4 multicast group information. See
multicasting.
Fig ure 203
MVR Multicast Television Example
Advanced Application > Multicast Setup
DESC RIPT IO N
Click the link to open screens where you can configure IGMP snooping and IGMP filtering for
IPv4.
Click the link to open screens where you can configure MLD snooping-proxy and MLD filtering
for IPv6.
Click the link to open screens where you can create multicast VLANs.
>
Multic a st
Advanced Application > Multicast > IPv4 Multicast
XS3800-28 User's Guide
Adva nc e d Applic a tio n
> to display the screen as shown. This screen
IPv4 Multic a st
Section 25.1 on page 269
273
> in the navigation
Multic a st
for more information on