ZyXEL Communications XS3800-28 User Manual page 102

The following table describes the labels in this screen.
Table 22 Basic Setting > IP Setup > IP Configuration
L ABEL DESC RIPT IO N
Default Type the IP address of the default outgoing gateway in dotted decimal notation, for example
Gateway 192.168.1.254.
Domain Name Enter a domain name server IPv4 address in order to be able to use a domain name instead of
Server 1/2 an IP address.
Default Specify which traffic flow (
Management from itself (such as SNMP traps) or packets with unknown source.
Select
. This means that devices connected to the other ports do not receive these packets.
MG MT
Select
(labeled
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
Out-of-band Management IP Address
Use these fields to set the settings for the out-of-band management port.
IP Address Enter the out-of-band management IP address of your Switch in dotted decimal notation. For
example, 192.168.0.1.
IP Subnet Enter the IP subnet mask of your Switch in dotted decimal notation, for example, 255.255.255.0.
Mask
Default Enter the IP address of the default outgoing gateway in dotted decimal notation, for example,
Gateway
192.168.0.254.
Apply Click
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Cancel Click
C a nc e l
IP Interface
Use these fields to create or edit IP routing domains on the Switch.
DHCP Client Select this option if you have a DHCP server that can assign the Switch an IP address, subnet
mask, a default gateway IP address and a domain name server IP address automatically.
Option-60 DHCP Option 60 is used by the Switch for identification to the DHCP server using the VCI
(Vendor Class Identifier) on the DHCP server. The Switch adds it in the initial DHCP discovery
message that a DHCP client broadcasts in search of an IP address. The DHCP server can assign
different IP addresses or options to clients with the specific VCI or reject the request from clients
without the specific VCI.
Select this and enter the device identity you want the Switch to add in the DHCP discovery
frames that go to the DHCP server. This allows the Switch to identify itself to the DHCP server.
Class-ID Type a string of up to 32 characters to identify this Switch to the DHCP server. For example, Zyxel-
TW.
Static IP Select this option if you do not have a DHCP server or if you wish to assign static IP address
Address
information to the Switch. You need to fill in the following fields when you select this option.
IP Address Enter the IP address of your Switch in dotted decimal notation, for example, 192.168.1.1. This is
the IP address of the Switch in an IP routing domain.
IP Subnet Enter the IP subnet mask of an IP routing domain in dotted decimal notation, for example,
Mask
255.255.255.0.
VID Enter the VLAN identification number to which an IP routing domain belongs.
Chapter 8 Basic Setting
In- Ba nd
to have the Switch send the packets to the management port labeled
O ut- o f- b a nd
to have the Switch send the packets to all ports except the management port
In- Ba nd
) to which connected devices do not receive these packets.
MG MT
to save your changes to the Switch's run-time memory. The Switch loses these
to reset the fields to your previous configuration.
to save your changes to the Switch's run-time memory. The Switch loses these
to reset the fields to your previous configuration.
XS3800-28 User's Guide
102
or ) the Switch is to send packets originating
O ut- o f- b a nd
link on the top navigation panel to save
Sa ve
link on the top navigation panel to save
Sa ve