Rip Configuration; Configuring Ipv4 Rip - ZyXEL Communications XS3800-28 User Manual

Table 203 Default Distance Value (continued)
RO UT E SO URC E
OSPF
RIP
49.2 RIP C o nfig ura tio n
Click
IP Applic a tio n
Click the link next to
version and direction for an IP interface.
IP Application > RIP
Fig ure 354
49.3 C o nfig uring IPv4 RIP
Click
IP Applic a tio n
manually configure a new entry. Each entry in the table is automatically created when you configure a
new IP domain in the
IP Application > RIP > IPv4 RIP
Fig ure 355
The following table describes the labels in this screen.
Table 204 IP Application > RIP > IPv4 RIP
L ABEL
Active
Distance
Index
ADMINIST RAT IVE DIST ANC E
110
120
> in the navigation panel to display the screen as shown.
RIP
to open a screen where you can enable RIP for IPv4 and configure the RIP
IPv4 RIP
> > in the navigation panel to display the screen as shown. You cannot
RIP IPv4 RIP
screen.
IP Se tup
DESC RIPT IO N
Select this check box to enable IPv4 RIP on the Switch.
Enter a number from 10 to 255 to specify the administrative distance that is assigned to routes
learned by RIP.
The lower the administrative distance value is, the more preferable the routing protocol is.
Note: You cannot set two routing protocols to have the same administrative distance.
This field displays the index number of an IP interface.
XS3800-28 User's Guide
Chapter 49 RIP
457