7.2.5 Restoring Factory Default Configuration - Comtech EF Data CDD-562L Installation And Operation Manual
Demodulator with ip module
Hide thumbs
Also See for CDD-562L:
- User manual (144 pages) ,
- User manual (150 pages) ,
- User manual (176 pages)
Table of Contents
Advertisement
CDD-562L/564 Demodulator with IP Module
Quick Start Guide
7.2.5 Restoring Factory Default Configuration
The remaining sections in this chapter assume that the CDM-IP is still in factory default
configuration for IP. If this is not the case, the factory default configuration may be restored from
the menu as follows:
Step
Task
1
From the Main Menu, select the Operations and Maintenance submenu [O].
2
From the Operations and Maintenance submenu, select Database Operations submenu [D].
3
From the Database Operations menu, select Restore Factory Default option [R].
4
When the following prompt is displayed:
Are you sure you want to restore factory default settings?
WARNING: Choosing Yes will restore factory defaults and then
reboot..
Type [Y] (yes) to confirm restore.
By completing the above procedure, this erases any user configurations made to date and restores
the CDD-56X to its factory default configuration.
Proceed to Section 7.3 to perform the Router Mode configuration.
7–5
Revision 2
MN/CDD564L.IOM
Advertisement
Table of Contents
Troubleshooting
Need help?
Do you have a question about the CDD-562L and is the answer not in the manual?
Questions and answers