Comtech EF Data CDD-562L Installation And Operation Manual page 234

CDD-562L/564 Demodulator with IP Module
Appendix D
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
QoS mode QSM= 1 byte, value of
1, 2 or 3.
Number of QOS QSN QSN=2 bytes
Rule entries numerical
QoS Typical QTL= 1-Byte value
System Latency 0 – 5 Seconds.
Query
Command or Query.
QoS operating mode, where:
1 = Priority/Max
2 = Min/Max
3 = DiffServ
Example: <1/QSM=2
Query Only.
Returns the number of active QoS rules. Does not count default rule.
Note: This command should be issued whenever a new rule is added/deleted.
Command or Query.
Sets/Gets the QoS typical system latency.
At low data rates of up to 1Mbps this value can range from 0 – 5 seconds.
At data rates above 1Mbps, the value range from 0 – 2 seconds.
Description of Arguments
D–18
Revision 2
MN/CDD564L.IOM
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
QSM = QSM? QSM =x
QSM! (see Description of Arguments)
QSN = QSN? QSN = xxx
QSN? (see Description of Arguments)
QTL = QTL? QTL=x
QTL! x = value of 0-5 Seconds.