Comtech EF Data CDD-562L Installation And Operation Manual page 228

CDD-562L/564 Demodulator with IP Module
Appendix D
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
Ping Reply Enabled PRE= 1 byte, value of
0 or 1
Enable/Disable QoS QSE= 1 byte value
Feature 0 – Disable
1 – Enable
RX Header RHE= 1 byte, value of
Compression 0, 1, 2 or 3
enable/disable
ReadOnly ROP= 11 bytes
Password No spaces
allowed.
ReadOnly ROU= 11 bytes
UserName No spaces
allowed.
ReadWrite RWP= 11 bytes
Password No spaces
allowed.
ReadWrite RWU= 11 bytes
UserName No spaces
allowed.
System None String of
Configuration Get Variable byte
size
SMTP Domain SDM= 128 bytes,
Name characters, no
spaces
Query
Command or Query.
Enables or disables ping reply, where:
0 = Disabled
1 = Enabled
Note: When disabled, the modem will not respond to pings (network security feature)
Command or Query.
Sets the Quality of Service feature, where:
0 = Disabled
1 = Enabled
Command or Query.
Enables or disables the Transmit 3xDES feature, where,
0 = Disabled
1 = Enabled
Restriction: Cannot enable if the 3xDES FAST feature has not been purchased
Command or Query.
Changes the ReadOnly password.
Example: ROP =comtech
Command or Query.
Changes the ReadOnly username.
Example: ROU=comtech
Note: To activate the new user name, ROP must be issued immediately after ROU.
Command or Query.
Changes the ReadWrite password.
Example: RWP=comtech
Command or Query.
Changes the ReadWrite username.
Example: RWU=comtech
Note: To activate the new user name, RWP must be issued immediately after RWU.
Query only.
Querying SCG? dumps the system configuration. This can be used for updating the GUI
parameters. See the Appendix section for more information on individual field.
Command or Query.
SMTP Domain name of up to 128 characters.
Note: Entering an empty string will delete the domain name. To delete the domain name,
issue <1/SDM=
Example: SMTP=somedomainname
Description of Arguments
D–12
Revision 2
MN/CDD564L.IOM
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
PRE = PRE? PRE=x
PRE! (see Description of Arguments)
QSE= QSE? QSE=x
QSE!
RHE = RHE? RHE =x
RHE! (see Description of Arguments)
ROP = ROP? ROP=xxxxxxxxxxx
ROP! (see Description of Arguments)
ROU = ROU? ROU=xxxxxxxxxx
ROU! (see Description of Arguments)
RWP = RWP? RWP=xxxxxxxxxxx
RWP! (see Description of Arguments)
RWU = RWU? RWU=xxxxxxxxxxx
RWU! (see Description of Arguments)
SCG= SCG? SCG=string of variable byte
SCG! size.
SDM = SDM? SDM=x [1..128]
SDM! (see Description of Arguments)