Comtech EF Data CDD-562L Installation And Operation Manual page 232

CDD-562L/564 Demodulator with IP Module
Appendix D
D.4.1.2 Interface Commands and Queries
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
Ethernet speed ESM= 1 byte, value of
mode 1..5
Ethernet MAC NONE 12 bytes
HDLC Address HAD 4 bytes,
Numerical
IP Address of IPA= 15 bytes length. Command or Query.
Ethernet interface
IP Address Mask of IPM= Value of
Ethernet Interface 8 – 32
Query
Command or Query.
Specifies the speed and mode of Ethernet interface, where:
1 = Auto
2 = 10 MB/sec Half Duplex
3 = 100 MB/sec Half Duplex
4 = 10 MB/sec Full Duplex
5 = 100 MB/sec Full Duplex
Query only.
Returns the Ethernet MAC address.
Example: ETM=0006B0000178
Command or Query.
Sets the one of four HDLC addresss, where:
In small network mode, value is 0x01-0xFE
In large network mode, value is 0x0001-0x7FFE
To delete, set the value to 0xFFFF.
Examples:
<1/HAD[3]=AB will set the HDLC address to 0xAB
<1/HAD[2]=FFFF will Clear/Delete the HDLC Address.
Note: In Point-to-Point or Vipersat modes, the values are not used.
Sets the IP address and mask of the Ethernet interface, in the format:
xxx.xxx.xxx.xxx where: xxx.xxx.xxx.xxx is the IP address.
Example: 010.006.030.001
Notes: To make the IPA= command effective, one needs to issue the IPM command
immediately following IPA command. IPM should be issued even if there is no change in
the subnet mask.
Changing the IP address will cause the telnet/socket connection to break. So, the
telnet/application should reconnect to the new IP address after timeout.
For Reading also, IPA? is followed by IPM?
Command or Query.
Sets the IP Subnet mask for the interface IP address, where:
yy is the submet mask in bits [8..32]
Refer to IPA Notes
Description of Arguments
D–16
Revision 2
MN/CDD564L.IOM
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
ESM = ESM? ESM = x
ESM! (see Description of Arguments)
ETM! ETM? ETM=xxxxxxxxxxxx
(see Description of Arguments)
HAD= HAD? HAD= xxxx
HAD! (see Description of Arguments)
IPA = IPA? IPA= xxx.xxx.xxx.xxx (see
IPA! Description of Arguments)
IPM= IPM? IPM=yy
IPM!