Comtech EF Data CDD-562L Installation And Operation Manual page 238

CDD-562L/564 Demodulator with IP Module
Appendix D
D.4.1.5 Operations and Maintenance Commands and Queries
Command Arguments for
Parameter (Instruction Command or
Type Code and Response to
Qualifier)
Base Modem Boot BBI= 1 byte value
From 0,1,2
Boot From Software BLI= 1 byte, value of
Image 0,1,2
Codecast Multicast CCA= Multicast IP
Address Address in
xxx.xxx.xxx.xxx
format
Load Params from LPS= 1-Byte value
permanent storage 1 – load
parameters
Param file image to PFI= 1 byte, value of
use 1 or 3
Query
Command or Query.
The binary image, which will be used by the base modem, to boot with, where:
0 = Latest
1 = Image in Slot# 1
2 = Image in Slot#2.
Example: <1/BBI=0
Command or Query.
Image which will be used the next time the system is booted, where:
0 = Latest
1 = Bulk Image # 1
2 = Bulk Image # 2
Example: BLI=1 (which is Image #1 active)
Command or Query.
Sets the Code cast multicast address, through which the modem can receive the software
updates via vLoad application. Only Multicast address in the range 224.xxx.xxx.xxx To
239.xxx.xxx.xxx are allowed. There are some reserved multicast addresses which cannot be
used.
This cannot be deleted.
Command only.
Set to '1' to load the system with parameters from permanent storage/flash. This may force
unit reboot, depending on the mode of operation.
Command or Query.
Image which will be updated the next time firmware is uploaded to the system:
1 = Param1
3 = Factory Default
To restore the Factory Defaults, set PFI=3 and issue RST to reset the box. This would
bring up the box with factory default configuration.
Example: PFI =1 (using param image on flash)
Description of Arguments
D–22
Revision 2
MN/CDD564L.IOM
Query
Response to (Instruction
Response to Query
Command Code and
Qualifier)
BBI= BBI? BBI=x
BBI! (see Description of Arguments)
BLI = BLI? BLI =x
BLI! (see Description of Arguments)
CCA= CCA? CCA=xxx.xxx.xxx.xxx
CCA! (see Description of Arguments)
LPS= N/A LPS=x
LPS! (see Description of Arguments)
PFI = PFI? PFI =x
PFI! (see Description of Arguments)