AGFA DX-D 400 User Manual page 81

Illustration 4-13
Detector Holder Assembly Procedure
0232F EN 20191213
To move the Holder in order to place it in its working position or to store it,
proceed as indicated below:
1. Unlock all wheels.
2. Push the Holder from its Vertical Bar and carry it where corresponds.
DRIVE THE EQUIPMENT WITH CARE. AVOID ANY IMPACT OF
THE UNIT WITH WALLS, FURNITURE OR OTHER ELEMENTS
IN THE ROOM THAT MAY CAUSE DAMAGE TO THE
EQUIPMENT AND/OR THE OTHER ROOM ELEMENTS.
DRIVE THE EQUIPMENT IN FLAT SURFACES. IF IT IS NOT
POSSIBLE, TRAVEL SURFACES SHOULD NOT EXCEED 5
INCLINATION RAMPS, EXCEEDING THIS ANGLE COULD
CAUSE SERIOUS DAMAGE TO THE EQUIPMENT, AND BY
USING IT UNDER THESE CONDITIONS COULD EVENTUALLY
REPRESENT A DANGER FOR THE USER.
HOLD ALWAYS THE VERTICAL BAR TO DRIVE CORRECTLY
THIS ACCESSORY EQUIPMENT.
Do not try to step over any possible obstacle when moving
the holder, the equipment could fall over.
ASSEMBLY PROCEDURE
Before its first use, the Holder must be mounted in the field as it is shipped
splitted. Refer to the image below for graphical information about its assembly
procedure.
1. Tighten the Column to the Trolley.
2. Mount the Detector Support and lock it with the Vertical Lock Lever.
DX-D 400
User Manual
o
71